Simply remove the 2 screws from the chrome cover of the standard knob and lift the cover off.
Unscrew the single Philips screw which is revealed when the cover is removed and slide the original knob from the shaft, using the screw driver gently tease both bearings out of the original knob along with the 2 shim washers.
Fit one bearing into the end of the new black spigot which will face the reel arm and slide back on to the reel arm shaft then fit the 2 shim washers followed by the bearing into the spigot and tighten the screw.
Finally once the spigot is mounted to the shaft screw the alloy knob on by turning clockwise and place the 7mm spanner over the hexagonal centre of the spigot and gently nip up.
No posts found